We may earn a commission on purchases made through links.
Unless you prefer to flush with a bidet, a toilet paper holder is an important bathroom amenity. If your bathroom doesn’t have one, you can always shop for a freestanding holder, but a better option is to install one yourself. YouTuber Living in DIY with Rachel Metz Features an innovative design that also creates extra storage space in your cluttered privy. The idea is to DIY a toilet paper shelving unit out of wood and attach it to your bathroom vanity next to your toilet. The cubby has a bin for used rolls, another underneath for storing backup rolls, and a tall one on the side to hold cleaning supplies or plungers. If you have scrap wood left over from past projects to make it with, this can be the most functional and Budget-friendly toilet paper storage hacks You can try.
For this to work, the side of the cabinet should be next to your toilet but not too close, as you need to leave enough. Space for toilet. Code requires 15 inches of clearance from the center of the toilet to the cabinet you built. Materials you need to assemble this project include your scrap wood pieces (eg, 1-by-6 or 2-by-6 pieces), finish nails, and wood glue, such as Titebond wood glue. If you want to stain or paint it, you’ll need sandpaper to prep the wood, as well as paint or stain and a clear protective finish, such as Varathne water based acrylic. If you decide to paint, do not forget about the wood primer. Without it, bare wood can absorb paint unevenly and leave stains. Make your life easier by choosing quick-drying and easy-to-clean water-based finishing products.
How to DIY a Side Vanity Toilet Paper Holder
To start this DIY, you’ll need four pieces of wood to make a rectangular box that fits next to the sink cabinet. Measure the dimensions for this frame, and Use a table saw or a miter saw to cut four boards to the proper length. The cabinet should be wide enough to store a stack of toilet paper on one side and your plunger on the other. You will then use one more piece of wood to split the cabinet in half height and use the shorter piece to make a compartment for the toilet roll holder. It’s six pieces together, all the same width.
Assemble the outer frame by spreading glue along the edges of the boards where they meet adjacent boards. Tape each joint together with finish nails. Next, install the dividers in the same way. If glue comes off any joint, wipe it off immediately with a damp cloth – it’s harder to remove if you wait. After the glue has set, you are ready to finish. The final tools you’ll need are 120-grit and 220-grit sandpaper, a rag, and a paintbrush. Sand the surface of the unit with medium-grit sandpaper and wipe off the dust before applying the primer. After priming, sand again with fine-grit sandpaper, and it’s ready to paint.
To install the cabinet, drive screws into it from the inside of the sink cabinet. The screws will not be visible, and they will be easy to access. You may want to add legs to lift the cabinet and legs to prevent items from falling. Instead of suspending the roll on twine, as Metz suggests in the video, you can easily install closet pole hardware sockets, such as Everbuilt socketsAnd use a wooden dowel to hold the roll.
